| 
The system comprises of a new 433Mhz radio receiver which replaces the 
original Stanley ET380 remote
controls 
  
UT2-433EG two channel keyfob
keyfob 
 
Up to two doors or gates can be 
controlled from each UT2-433EG keyfob 
(The AP433RX2 is a two channel receiver unit and may 
be connected to two separate door or gate motors)
 This keyfob replaces the AP433TX4 
 
Simple D.I.Y. Installation 
Quick & simple DIY installation, our upgrade kit can be fitted 
to your existing Stanley ET380
garage
door operator in minutes without any technical knowledge! 
This upgrade can be fitted to most garage door operators including
Alltronik,
Bosch,
Chamberlain,
Liftmaster,
Merlin,
Rallye & any other system 
with connections for a wall mounted pushbutton control 
 | 
 
 | 
 The 
receiver unit is supplied with a 13A 
mains plug type power adaptor & 7Mtrs of low voltage flex and simply
plugs into a normal household mains socket and connects by
two wires to the low voltage wall
mounted pushbutton switch connections on the rear panel of the Stanley ET380 garage door operator. 
(labelled 'BLK' & 'RED' below) 
Click image to enlarge 
  
 Connect the pair of wires from the new 
AP433RX2 
receiver to
the top right
terminals on the ET380 
(the pair of wires to from your wall mounted 
pushbutton switch should remain connected) Note: 
The AP433RX2 remote control upgrade receiver unit connects to the same circuit as the wall mounted control switch therefore 
it's essential that your door functions normally from the 'Door' control pushbutton so please make sure your door works from this 
button before ordering a remote control upgrade kit.  |