A convenient & easy to fit remote control upgrade to suit Cardale Steel-Line & AutoGlide garage door operator that can be fitted within
about 5 minutes with no technical knowledge, we even supply a screwdriver !
The Seip EKR1MCT/13A remote control receiver unit is fitted with a 13A mains plug & 7Mtrs of low voltage flex and simply
plugs into a normal household mains socket and connects by two wires to the low voltage wall
mounted pushbutton switch connections on your existing garage door operator
system.
Wiring connections
If you have a Cardale Autoglide III operator you'll find a pale green two pin plug
beside the black 3 pin mains input plug on the underside of the motor housing
as shown below.
Click image to enlarge
Note: the wall mounted
pushbutton switch (if fitted) should
remain connected to the pale green plug in addition to the new Seip remote control receiver. |
Click image to enlarge
Seip
EKR1MCT/13A mains powered radio control receiver unit with
13A mains plug & 7Mtr
extended flex
receiver module dimensions 84mm x 26mm x 19mm
(shown with mini & midi keyfobs)
Cardale Autoglide Mk I & II
A pale green two pin plug for the pushbutton switch will be found inside the
triangular wall mounted control box on an Autoglide Mk I or Mk II operator.
Note: It's essential that your Autoglide operator functions normally
from the wired-in pushbutton so please confirm that your door works properly from this before ordering a Seip remote control
upgrade.
If a pushbutton switch has not been installed and you are unsure which terminals you need to connect to on your operator, please click here to contact our friendly technical support staff who are on standby to assist with any query.
|