1/ Programming the desired hand transmitter button
Push the P button on the Ecostar operator motor cover briefly. The red LED will begin to
flash, signalising that the desired hand transmitter button can be programmed.
To do so, the hand transmitter button must be held down until the LED begins
flashing rapidly. The hand transmitter button must then be released and pushed
again within 15 seconds, until the LED begins flashing very rapidly. Now,
release the hand transmitter button. Once the rapid flashing stops, the desired
hand transmitter button has been successfully programmed and the red LED will
remain lit.
2/ Deleting the remote control memory in the radio receiver
(recommended if a handset has been lost or stolen)
Push the 'T' button on the operator cover and hold it down. The
red LED will flash slowly for approx. 4 seconds, signalising readiness for
deletion. The flashing rhythm becomes more rapid. Now, release the P button.
Note: The deletion process will be aborted if the P button is released before 4
seconds have elapsed. Once the rapid flashing stops, all memory spaces have been
deleted and the red LED will remain lit. Follow the programming procedure to
re-programme your keyfobs
Full documentation for the Hormann Ecostar operator can be
downloaded here
To order new Ecostar transmitters
Click here
01384 900 264
*
*
