Method A
(requires an existing working transmitter)
step 1/
Take an existing active transmitter (one that has already been
programmed into the receiver) press & hold both buttons for
approx. 5 seconds and release, the receiver module should
'bleep' to indicate it is ready to learn a transmitter code.
step 2/ Take the new transmitter you wish to program and
press the small red button. The receiver
will 'bleep' to indicate it has memorised a new
transmitter code. After 10 seconds the receiver will
'bleep twice' to indicate programming is complete. -
your new keyfob is ready for use. |
|
Method B
(requires access to the receiver module)
step 1/
Locate the programming button on the receiver module in the garage and briefly
press this button, the receiver will 'bleep' to indicate it
is
ready to learn a transmitter code.
step 2/ same as in method A
Erasing the memory
(necessary if a handset has been lost or stolen)
Locate the small red programming button on the receiver module, press & hold the
button for 10 seconds, the receiver will 'bleep' three times to
indicate all codes in the memory have been erased, follow method
B above to re program your transmitters
Cardale Steel-line
Installation Manual
(pdf download) |
01384 900 264
